Difference between revisions of "Firmware-830 Command-093"
| Line 1: | Line 1: | ||
==WIRELESS (93, 5Dh)== | ==WIRELESS (93, 5Dh)== | ||
| − | This command sets the BLE-MIDI (MIDI via Bluetooth Low Energy), if WiConnect for BLE-MIDI is installed, or WiFi status, if WiConnect for WiFi is installed, of the WiDig. Upon first use, BLE-MIDI or WiFi is disabled. If WiConnect for BLE-MIDI is installed, the BLE-MIDI command configures the WiDig to set the baud rate of the WiDig COM port to 31.25 kbps immediately as well as upon power-up. If WiConnect for WiFi is installed, the WiDig COM port always operates at 115.2 kbps. Upon completion of the command the WiDig sends out the same message as the command. | + | This command sets the BLE-MIDI (MIDI via Bluetooth Low Energy), if WiConnect for BLE-MIDI is installed, or WiFi status, if WiConnect for WiFi is installed, of the WiDig. Upon first use, BLE-MIDI or WiFi is disabled. If WiConnect for BLE-MIDI is installed, the BLE-MIDI command configures the WiDig to set the baud rate of the WiDig internal COM port to 31.25 kbps immediately as well as upon power-up. If WiConnect for WiFi is installed, the WiDig internal COM port always operates at 115.2 kbps. Upon completion of the command the WiDig sends out the same message as the command. |
The [BODY] of the WIRELESS command is: | The [BODY] of the WIRELESS command is: | ||
Latest revision as of 18:25, 7 June 2023
WIRELESS (93, 5Dh)
This command sets the BLE-MIDI (MIDI via Bluetooth Low Energy), if WiConnect for BLE-MIDI is installed, or WiFi status, if WiConnect for WiFi is installed, of the WiDig. Upon first use, BLE-MIDI or WiFi is disabled. If WiConnect for BLE-MIDI is installed, the BLE-MIDI command configures the WiDig to set the baud rate of the WiDig internal COM port to 31.25 kbps immediately as well as upon power-up. If WiConnect for WiFi is installed, the WiDig internal COM port always operates at 115.2 kbps. Upon completion of the command the WiDig sends out the same message as the command.
The [BODY] of the WIRELESS command is:
| 0xxxxxxx: | xxxxxxx = 0; WIRELESS off |
| xxxxxxx = [1..127]; WIRELESS on |
