Firmware-72 Command-057

From I-CubeX Wiki
Revision as of 14:15, 3 November 2015 by Admin (talk | contribs) (Created page with "==SEND OUTPUT PULSE (57, 39h)== The SEND OUTPUT PULSE command can be used to get the output pulse type as specified by its interval and width range and which applies to all o...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

SEND OUTPUT PULSE (57, 39h)

The SEND OUTPUT PULSE command can be used to get the output pulse type as specified by its interval and width range and which applies to all outputs at the same time. The command can be used in both host and stand-alone modes of operation. Upon completion of the command the digitizer sends out the same message as the SET OUTPUT PULSE command but with the command ID byte set to 57 (39h).

The SEND OUTPUT PULSE command has no [BODY].

Example:

240, 125, 0 {DEV}, 57 {SEND OUTPUT PULSE}, 247 (F0h, 7Dh, 00h, 39h, F7h)

Retrieved from "https://infusionsystems.com/support/wiki/index.php?title=Firmware-72_Command-057&oldid=278"