Firmware-810 Command-107

DUMP CONFIG (107, 6Bh)

The DUMP CONFIG command is used to obtain the current settings of the WiDig. Upon completion of the command the WiDig sends out the 9-byte CONFIG message.

The WiDig will send out the configuration of a WiDig sensor input when using the DUMP CONFIG command with the following [BODY]:

00000001:	1; configuration number
00bbbaaa:	aaa = [0..7]; sensor input number
	bbb = [0..7]; virtual input number

The Digitizer will send out the configuration of each WiDig binary output as well as the sample interval value when using the DUMP CONFIG command with a special value for the 2nd data byte in the [BODY]:

00000001:	1; configuration number
01111111:	127; actuator outputs flag