Firmware-75 Commands

From I-CubeX Wiki
Revision as of 21:01, 4 October 2017 by Admin (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

General

This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.


Standalone Mode

This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.


Dual Mode

This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.