Firmware-72 Format

From I-CubeX Wiki
Revision as of 03:31, 3 November 2015 by Admin (talk | contribs) (Created page with "Infusion Systems I-CubeX USB-microDig MIDI implementation uses the following data format for all system exclusive messages: Byte Description 240 (F0h) System Exclusive Status...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Infusion Systems I-CubeX USB-microDig MIDI implementation uses the following data format for all system exclusive messages:

Byte Description 240 (F0h) System Exclusive Status 125 (7Dh) Manufacturer ID {DEV} Device ID {CMD} Command or Message ID [BODY] Main Data 247 (F7h) End of System Exclusive


Manufacturer ID

The manufacturer identifies the manufacturer of a MIDI device. Infusion Systems uses the number 125 (7Dh). Infusion Systems does not own the manufacturer ID 125 (7Dh). This ID is usually reserved for general educational and/or research equipment. Please ensure that you do not have any devices with manufacturer ID 125 (7Dh) in your MIDI chain.


Device ID

This ID identifies a specific USB-microDig in setups with multiple USB-microDigs. This setting should remain 0 for use of the USB-microDig in stand-alone mode. Host mode allows for device IDs other than 0.


Command and Message IDs and [Main Data]

The Command and Message IDs and [Main Data] form the protocol for communication with the USB-microDig. The protocol consists of commands that are sent to the USB-microDig and messages that are sent by the USB-microDig. The Command and Message ID description and [Main Data] formats are described starting on the next page.

Retrieved from "https://infusionsystems.com/support/wiki/index.php?title=Firmware-72_Format&oldid=227"