Connect-150 Firmware Upload
The firmware upload utility allows you to upload the latest firmware to your digitizer. This utility is available from the digitizer view window. Clicking the "Check Firmware" button in the digitizer view will check whether a new firmware version is available for the connected digitizer. Follow the instructions shown in the digitizer view to complete the upload. The firmware upload feature is available for USB-microDigs with hardware v7.1 or higher and for Wi-microDigs with hardware v6.0 or higher.
By clicking the "Check Firmware" button while holding down the option button, you can select a specific firmware file to be uploaded so that it's possible to downgrade or upload custom versions (available upon request).
For Wi-microDigs, you will be asked to press and hold a button while powering it up. This button is located right next to the blue "link" LED as shown in the image below. It is a little hard to press so as to avoid setting the digitizer accidentally into firmware upload mode.