Firmware-800 Command-093
Revision as of 15:28, 29 May 2018 by Admin (talk | contribs) (Copied from Firmware-80 Command-093, revision 3031)
BLE-MIDI (93, 5Dh)
This command sets the BLE-MIDI (MIDI via Bluetooth Low Energy) status of the WiDig. Upon first use, BLE-MIDI is disabled. The BLE-MIDI command configures the WiDig to set the baud rate of the WiDig COM port to 31.25 kbps immediately as well as upon power-up. In addition to MIDI communication via BLE, if a USB-microMIDICable is plugged into the WiDig's USB microB connector its MIDI messages are output and can be sent to another MIDI device. The USB-microMIDICable cannot receive MIDI messages. Upon completion of the command the WiDig sends out the same command.
The [BODY] of the BLE-MIDI command is:
| 0xxxxxxx: | xxxxxxx = 0; BLE-MIDI off |
| xxxxxxx = [1..127]; BLE-MIDI on |
