Firmware-811 Command-031

DUMP TABLE (31, 1Fh)

The DUMP TABLE command retrieves a lookup table with 1024 values that’s stored in non-volatile memory. The command can be used in both host and stand-alone modes of operation. Upon completion of the DUMP TABLE command the WiDig sends out the same message as the TABLE ENTRY command, for each of the 1024 entries. This command is not available for digitizers with hardware v7.0 or lower.

The [BODY] of the DUMP TABLE command contains a single 7-bit byte:

000nnnnn:

nnnnn = [0..31]; table number

Example:

To download table 4 from a WiDig, send the following message:

240, 125, 0 {DEV}, 31 {DUMP TABLE}, 4 {table number}, 247 (F0h, 7Dh, 00h, 1Fh, 04h, F7h)