WiConnect
WiConnect manages the USB, BLE-MIDI or WiFi-OSC/WS communications of the WiDig. It runs on the WiDig together with its other firmware.
Use Connect (v1.6.4 or higher for MacOS, v1.54 or higher for Windows) to find out which version of WiConnect is running on the WiDig. Click on the text "Firmware" (not the firmware number) in the upper left corner of Connect to switch to displaying the WiConnect version information. Click again, now on the text "WiConnect", to switch back to the firmware information.
WiConnect can be uploaded using DoayeeESP32DFU for MacOS or Windows.
To upload one of WiConnect versions listed below, execute the following steps (do not click the "Erase ESP" button):
- In Connect, verify that the firmware version matches the one required as per the information in the Releases section below.
- Click the link below under Releases, of the WiConnect version you want to upload to the WiDig, to download it to your computer.
- Click "Remove" in the digitizer view of the WiDig entry in Connect. Make sure no other software is using the serial port of the WiDig.
- Open DoayeeESP32DFU. You may need to right-click (or click-while-holding-down-the-control-key) the app to open it. See below under Known Issues.
- Select the Serial Port (contains the text "SLAB" on MacOS and "COM" on Windows) from the pull-down menu.
- Set the Baud Rate to 926100.
- Click the Browse button in the "Flash App .." row to select the WiConnect file from your computer.
- Click "Flash".
- When the text "Hard Resetting via RTS pin" appears in the terminal window the upload is completed.
- Click "Refresh Devices" from the pull-down menu in Connect to start using the WiDig.
Releases
- 02 Mar 2022: WiConnect 1.201 BLE-MIDI client/server with USB pass-thru and LED control (requires firmware 8.20 or higher)
- 17 Oct 2020: WiConnect 1.104 BLE-MIDI client/server with USB pass-thru and LED control (requires firmware 8.12)
- 01 May 2019: WiConnect 1.002 BLE-MIDI server without USB pass-thru (requires firmware 8.12 or lower)
Pre-Releases
- 27 Jul 2020: WiConnect 1.919 WiFi-OSC/WS with USB pass-thru and LED control (requires firmware 8.12)
Known Issues
- WiConnect 1.919: it is not recommended to use a sampling interval smaller than 10 ms as it might not be possible to communicate with the WiDig, requiring clearing the configuration or even re-uploading the firmware and WiConnect.
- DoayeeESP32DFU: If on MacOS you get a warning from Apple's GateKeeper that it can't run and should be moved to the trash then the easiest way around this is to right-click (or click-while-holding-down-the-control-key) the app. This will give you the option to open the app.
- ESPFlasherGUI does not run on MacOS Sierra. On MacOS Catalina it greys out buttons after uploading - restart if more uploads are needed.