Firmware-830 Command-093

From I-CubeX Wiki
Revision as of 15:44, 7 June 2023 by Admin (talk | contribs)
Jump to: navigation, search

WIRELESS (93, 5Dh)

This command sets the BLE-MIDI (MIDI via Bluetooth Low Energy), if WiConnect for BLE-MIDI is installed, or WiFi status, if WiConnect for WiFi is installed, of the WiDig. Upon first use, BLE-MIDI or WiFi is disabled. If WiConnect for BLE-MIDI is installed, the BLE-MIDI command configures the WiDig to set the baud rate of the WiDig COM port to 31.25 kbps immediately as well as upon power-up. If WiConnect for WiFi is installed, the WiDig COM port always operates at 115.2 kbps. Upon completion of the command the WiDig sends out the same message as the command.

The [BODY] of the WIRELESS command is:

0xxxxxxx: xxxxxxx = 0; WIRELESS off
xxxxxxx = [1..127]; WIRELESS on
Retrieved from "https://infusionsystems.com/support/wiki/index.php?title=Firmware-830_Command-093&oldid=6679"