Firmware-800 Command-093

From I-CubeX Wiki
Jump to: navigation, search

BLE-MIDI (93, 5Dh)

This command sets the BLE-MIDI (MIDI via Bluetooth Low Energy) status of the WiDig. Upon first use, BLE-MIDI is disabled. The BLE-MIDI command configures the WiDig to set the baud rate of the WiDig COM port to 31.25 kbps immediately as well as upon power-up. In addition to MIDI communication via BLE, if a USB-microMIDICable is plugged into the WiDig's USB microB connector its MIDI messages are output and can be sent to another MIDI device. The USB-microMIDICable cannot receive MIDI messages. Upon completion of the command the WiDig sends out the same command.

The [BODY] of the BLE-MIDI command is:

0xxxxxxx: xxxxxxx = 0; BLE-MIDI off
xxxxxxx = [1..127]; BLE-MIDI on
Retrieved from "https://infusionsystems.com/support/wiki/index.php?title=Firmware-800_Command-093&oldid=3076"