|
Detects movement within a range of 7 m. Be there not or be I-CubeX-ed.
See this videoclip for a demo !
To capture direction and speed of visitors passing by an exhibit or installation, check the MoveAlong. Need lots of detail ? Try the MoveAround.
Application examples
- Use for detection of motion in rooms (doesn't detect presence of objects or humans, because only movement is detected).
Use two or more to determine the direction of a movement.
- Combine with a
TapTiled floor,
some Advance-645 and/or ReachClose
sensors and make sure every move of your visitor has an effect.
Perhaps the TouchStripOn
is useful for additional coverage on walls.
The Flash +
SeeLaser
combo allows you to implement break-beams that could indicate borders or thresholds.
Technical specifications
Product |
MoveOn sensor |
Version |
1.5 (June 2012) |
Sensing parameter |
motion of heat emitting object |
Sensing method |
infrared (micrometer spectrum) differential |
Active volume |
110° cone |
Range |
7 m |
Resolution |
1 bit (on or off) |
Reset time |
~ 0.5 - 15 s (duration the sensor outputs max value upon motion detection) |
Calibration |
Motion |
Voltage (use 5 V power supply) |
7-bit MIDI value (use 'no processing' editor preset) |
no |
0.00 |
0 |
yes |
3.3 |
84 |
Power supply |
3 to 5 V DC, 0.05 mA |
Operating conditions |
0° to 70° C (32° to 158° F) |
Sensor dimensions |
38 mm (1.5 inch) x 30 mm (1.2 inch) x 28 mm (1.1 inch) |
Weight |
15 g (0.53 oz), incl. cable |
Cable |
1.0 m (39 inch), shielded, red wire = power, uninsulated wire = ground, black wire = sensor output, maximum extension 30 m (98 ft) |
Connector |
male plug with 3 pins in a row spaced 2.54 mm (0.100 inch) |
Application notes |
- Make sure the sensor is plugged into the Digitizer with the red wire connected to power. Reversing the plug may cause damage to the sensor.
- The MoveOn sensor needs a couple of seconds before it is ready for stable operation.
- The reset time can be adjusted using the orange phillips screw.
- Best results are obtained if the sensor is placed up high, about 2 to 3 meter (7 to 10 feet) in the area it is being used in.
- The unit may not be suited for environments with rapid temperature changes due to wind, heating devices or air conditioners, or environments with shocks and vibrations or environments with sunlight or other intense light aimed directly at the sensor.
|
|