An LED that provides visual feedback.
- It's pretty neat as an elevated-tech Christmas tree decoration.
- Use it to monitor the status of your gear.
||2.3 (September 2020)|
||yellow LED indicator|
||5 V DC, 6 mA|
||20 x 11 x 4 mm (0.79 x 0.43 x 0.16 inch)|
||one 2.5 mm (0.10 inch) hole|
||0.50 m (20 inch), shielded, red wire = power, black wire = ground, white wire = n/c, extendable at least 100 m (328 ft) with ExtendCableD-10|
||male 1x4 plug with 3 pins in a row spaced 2.54 mm (0.100 inch)|
||6 g (0.2 oz), incl. cable|
- Our EditorX software allows you to configure the digitizer to control multiple actuators simultaneously with on/off as well as PWM signals.
- Our Link software allows you to control multiple actuators simultaneously with on/off signals.
- Can be controlled with an actuator output using on (5V) / off (0V) signals, as well as pulse width modulated (PWM) signals.
- Since actuator outputs provide less current than the 5V power supply, the LED will not be a bright as when connected with the 5V power supply, which requires moving the pin connected to the red wire. Take this pin out of the slot by slightly lifting the plastic lever with a pointy or sharp object and then push the pin in the 5V power slot such that the lever clicks into place and the pin can't be pushed out.
- The plug is compatible with a WiDig or USB-microDig such that it can be turned on and off with an AUX output.
- To turn it on and off with a Digitizer output (ie. the power supply pins of inputs 25 - 32) the pin connected to the red wire has to be moved. Take this pin out of the slot by slightly lifting the plastic lever with a pointy or sharp object and then push the pin in the 5V power slot such that the lever clicks into place and the pin can't be pushed out.
- To turn it on and off with a Wi-microDig, it must run firmware v6.3. Move the pin of the plug that is connected to the red wire to the position of the pin connected to the white wire, which wire is not connected to anything and can be removed..