Difference between revisions of "Firmware-633 Commands"
(→Dual Mode) |
|||
| Line 8: | Line 8: | ||
*[[Firmware-73 Command-060 |OUTPUT INIT (60, 3Ch)]] | *[[Firmware-73 Command-060 |OUTPUT INIT (60, 3Ch)]] | ||
| − | *[[Firmware- | + | *[[Firmware-733 Command-071 |DUMP VERSION (71, 47h)]] |
*[[Firmware-733 Command-066 |DUMP FIRMWARE VERSION (66, 42h)]] | *[[Firmware-733 Command-066 |DUMP FIRMWARE VERSION (66, 42h)]] | ||
Revision as of 21:51, 11 January 2018
Since many firmware 6.2 commands are the same as used in firmware 7.2, reference is made to firmware 7.2 information where applicable.
General
This section describes the messages and commands for resetting the Wi-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining the Bluetooth port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
