Difference between revisions of "Firmware-633 Commands"
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Since many firmware 6. | + | Since many firmware 6.33 commands are the same as used in firmware 7.3/7.33, reference is made to firmware 7.3/7.33 information where applicable. |
==General== | ==General== | ||
| Line 31: | Line 31: | ||
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode. | This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode. | ||
| − | *[[Firmware- | + | *[[Firmware-633 Command-100 |EDIT NAME (100, 64h)]] |
| − | *[[Firmware- | + | *[[Firmware-633 Command-101 |DUMP NAME (101, 65h)]] |
*[[Firmware-633 Command-105 |CLEAR CONFIG (105, 69h)]] | *[[Firmware-633 Command-105 |CLEAR CONFIG (105, 69h)]] | ||
*[[Firmware-633 Command-106 |EDIT CONFIG (106, 6Ah)]] | *[[Firmware-633 Command-106 |EDIT CONFIG (106, 6Ah)]] | ||
| − | *[[Firmware- | + | *[[Firmware-633 Command-107 |DUMP CONFIG (107, 6Bh)]] |
==Dual Mode== | ==Dual Mode== | ||
Latest revision as of 20:38, 4 December 2018
Since many firmware 6.33 commands are the same as used in firmware 7.3/7.33, reference is made to firmware 7.3/7.33 information where applicable.
General
This section describes the messages and commands for resetting the Wi-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining the Bluetooth port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
