Difference between revisions of "Firmware-641 Messages"
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
Note that in the following listing the commands as echoed back by the Wi-microDig (to allow multiple Max/MSP objects to work with a Wi-microDig) are not included. | Note that in the following listing the commands as echoed back by the Wi-microDig (to allow multiple Max/MSP objects to work with a Wi-microDig) are not included. | ||
| − | Since many firmware 6.41 messages are the same as used in firmware 8. | + | Since many firmware 6.41 messages are the same as used in firmware 8.11, reference is made to firmware 8.11 information where applicable. |
| Line 19: | Line 19: | ||
*[[Firmware-811_Message-101 |NAME (101, 65h)]] | *[[Firmware-811_Message-101 |NAME (101, 65h)]] | ||
| − | *[[Firmware-811_Message- | + | *[[Firmware-811_Message-107 |CONFIG (107, 6Bh)]] |
Latest revision as of 03:34, 27 July 2020
Note that in the following listing the commands as echoed back by the Wi-microDig (to allow multiple Max/MSP objects to work with a Wi-microDig) are not included.
Since many firmware 6.41 messages are the same as used in firmware 8.11, reference is made to firmware 8.11 information where applicable.
General
- SOLO (33, 21h)
- RESET ACK (35, 23h)
- STATUS (37, 25h)
- VERSION (71, 47h)
- FIRMWARE VERSION (66, 42h)
- MODE (91, 5Bh)
- LOW POWER LEVEL (111, 6Fh)
- BATTERY VOLTAGE LEVEL (114, 6Fh)
Standalone Mode
