Difference between revisions of "Firmware-820 Messages"
(Created page with "Note that in the following listing the commands as echoed back by the WiDig (to allow multiple Max/MSP objects to work with a WiDig) are not included. Since many firmware 8.2...") |
|||
| Line 6: | Line 6: | ||
==General== | ==General== | ||
| − | *[[Firmware-811_Message- | + | *[[Firmware-811_Message-035 |RESET ACK (35, 23h)]] |
| − | + | ||
| − | |||
| − | |||
*[[Firmware-811_Message-091 |MODE (91, 5Bh)]] | *[[Firmware-811_Message-091 |MODE (91, 5Bh)]] | ||
| + | |||
*[[Firmware-811_Message-051 |MUTE (51, 33h)]] | *[[Firmware-811_Message-051 |MUTE (51, 33h)]] | ||
| − | |||
*[[Firmware-811_Message-033 |SOLO (33, 21h)]] | *[[Firmware-811_Message-033 |SOLO (33, 21h)]] | ||
| + | |||
| + | *[[Firmware-811_Message-096 |BLE-MIDI (96, 60h)]] | ||
| + | *[[Firmware-811_Message-095 |MIDI STATUS (95, 60h)]] | ||
*[[Firmware-811_Message-037 |STATUS (37, 25h)]] | *[[Firmware-811_Message-037 |STATUS (37, 25h)]] | ||
| + | |||
| + | *[[Firmware-811_Message-066 |FIRMWARE (66, 42h)]] | ||
*[[Firmware-811_Message-071 |VERSION (71, 47h)]] | *[[Firmware-811_Message-071 |VERSION (71, 47h)]] | ||
| + | |||
| + | *[[Firmware-812_Message-111 |LOW POWER (111, 6Fh)]] | ||
| Line 28: | Line 33: | ||
*[[Firmware-811_Message-004 |SAMPLE DATA (4, 04h)]] | *[[Firmware-811_Message-004 |SAMPLE DATA (4, 04h)]] | ||
*[[Firmware-811_Message-000 |STREAM DATA (0, 00h)]] | *[[Firmware-811_Message-000 |STREAM DATA (0, 00h)]] | ||
| + | |||
*[[Firmware-811_Message-010 |I2C DATA (10, 0Ah)]] | *[[Firmware-811_Message-010 |I2C DATA (10, 0Ah)]] | ||
*[[Firmware-811_Message-123 |I2C NO RESPONSE (123, 7Bh)]] | *[[Firmware-811_Message-123 |I2C NO RESPONSE (123, 7Bh)]] | ||
Revision as of 20:23, 15 February 2022
Note that in the following listing the commands as echoed back by the WiDig (to allow multiple Max/MSP objects to work with a WiDig) are not included.
Since many firmware 8.20 commands are the same as used in firmware 8.12 and 8.11, reference is made to firmware 8.12 or 8.11 information where applicable.
General
Standalone Mode
