Difference between revisions of "Firmware-811 Commands"
(2 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
==General== | ==General== | ||
− | This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation | + | This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode. |
*[[Firmware-811 Command-034 |RESET (34, 22h)]] | *[[Firmware-811 Command-034 |RESET (34, 22h)]] | ||
*[[Firmware-811 Command-060 |OUTPUT INIT (60, 3Ch)]] | *[[Firmware-811 Command-060 |OUTPUT INIT (60, 3Ch)]] | ||
− | *[[Firmware-811 Command-066 |DUMP FIRMWARE (66, 42h)]] | + | *[[Firmware-811 Command-066 |DUMP FIRMWARE VERSION (66, 42h)]] |
*[[Firmware-811 Command-071 |DUMP VERSION (71, 47h)]] | *[[Firmware-811 Command-071 |DUMP VERSION (71, 47h)]] | ||
Line 23: | Line 23: | ||
*[[Firmware-811 Command-096 |DUMP BLE-MIDI (96, 60h)]] | *[[Firmware-811 Command-096 |DUMP BLE-MIDI (96, 60h)]] | ||
− | *[[Firmware-811 Command-094 |MIDI | + | *[[Firmware-811 Command-094 |MIDI CONFIG (94, 5Eh)]] |
− | *[[Firmware-811 Command-095 |DUMP MIDI | + | *[[Firmware-811 Command-095 |DUMP MIDI CONFIG (95, 5Fh)]] |
Latest revision as of 16:02, 5 March 2022
General
This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.