Difference between revisions of "Connect-165 OSC Input"
(Created page with " If the OSC messages match (case insensitive) the format /<digitizer_name>/<output_name> <set_value>, where digitizer_name is the name of a connected digitizer, and set_value...") |
|||
| Line 4: | Line 4: | ||
The following OSC messages can be sent: | The following OSC messages can be sent: | ||
{| | {| | ||
| − | |<b>OSC Message</b> | + | |<b>set_value of OSC Message</b> |
|<b>Action</b> | |<b>Action</b> | ||
|- | |- | ||
| Line 14: | Line 14: | ||
|- | |- | ||
|128 (or more) or "on" (case insensitive) | |128 (or more) or "on" (case insensitive) | ||
| − | | | + | |turn output on |
|- | |- | ||
|} | |} | ||
Revision as of 21:36, 8 March 2022
If the OSC messages match (case insensitive) the format /<digitizer_name>/<output_name> <set_value>, where digitizer_name is the name of a connected digitizer, and set_value is in {.. -128, 0 .. 127, 128 .. }, the set_value will be mapped to a SET OUTPUT message (see the firmware pages).
The following OSC messages can be sent:
| set_value of OSC Message | Action |
| 0 .. 127 | enable and set pulse width modulation (if implemented) or set the I2C actuator method as per OSC message value |
| -128 (or less) or "off" (case insensitive) | turn output off |
| 128 (or more) or "on" (case insensitive) | turn output on |
For example, "/USB-microDig_0123/Output_01 64" will set an actuator output configured for a PWM actuator to output a pulse with a width that's half of the configured range, so in case of the default PWM configuration (ie. 1 ms range, from 1 to 2 ms) that would be 1.5 ms.
Sending the same message while the actuator output is configured for an I2C actuator will set the actuator method of the I2C actuator to 64.
