Difference between revisions of "Connect-170 OSC Input"
(Copied from Connect-165 OSC Input, revision 5970) |
|||
| Line 1: | Line 1: | ||
| − | Connect can receive OSC messages to control actuator outputs of a digitizer. See the [[Connect- | + | Connect can receive OSC messages to control actuator outputs of a digitizer. See the [[Connect-166_Preferences | preferences]] section to configure Connect for this feature. |
If the OSC messages match (case insensitive) the format "/<digitizer_name>/<output_name> <set_value>", where digitizer_name is the name of a connected digitizer, and set_value is in {.. -128, 0 .. 127, 128 .. }, the set_value will be mapped to a SET OUTPUT message (see the [[Firmware |firmware]] pages) as follows: | If the OSC messages match (case insensitive) the format "/<digitizer_name>/<output_name> <set_value>", where digitizer_name is the name of a connected digitizer, and set_value is in {.. -128, 0 .. 127, 128 .. }, the set_value will be mapped to a SET OUTPUT message (see the [[Firmware |firmware]] pages) as follows: | ||
Revision as of 02:22, 19 April 2023
Connect can receive OSC messages to control actuator outputs of a digitizer. See the preferences section to configure Connect for this feature.
If the OSC messages match (case insensitive) the format "/<digitizer_name>/<output_name> <set_value>", where digitizer_name is the name of a connected digitizer, and set_value is in {.. -128, 0 .. 127, 128 .. }, the set_value will be mapped to a SET OUTPUT message (see the firmware pages) as follows:
| set_value of OSC Message | Action |
| 0 .. 127 | enable and set pulse width modulation (if implemented) or set the I2C actuator method as per OSC message value |
| -128 (or less) or "off" (case insensitive) | turn output off |
| 128 (or more) or "on" (case insensitive) | turn output on |
The pulse width value maximum is 125.
Example:
The OSC message "/USB-microDig_0123/Output_01 62" will set an actuator output configured for a PWM actuator to output a pulse with a width that's half of the configured range, so in case of the default PWM configuration (ie. 1 ms range, from 1 to 2 ms) that would be 1.5 ms.
Sending the same message while the actuator output is configured for an I2C actuator will set the actuator method of the I2C actuator to 62.
