Difference between revisions of "Firmware-72 Command-107"
(Created page with "==DUMP CONFIG (107, 6Bh)== The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out a CON...") |
|||
| Line 1: | Line 1: | ||
==DUMP CONFIG (107, 6Bh)== | ==DUMP CONFIG (107, 6Bh)== | ||
| − | The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out | + | The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out the [[Firmware-72_Message-106 |CONFIG message]]. |
The USB-microDig will send out the configuration of a USB-microDig sensor input when using the DUMP CONFIG command with the following [BODY]: | The USB-microDig will send out the configuration of a USB-microDig sensor input when using the DUMP CONFIG command with the following [BODY]: | ||
Latest revision as of 17:24, 3 November 2015
DUMP CONFIG (107, 6Bh)
The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out the CONFIG message.
The USB-microDig will send out the configuration of a USB-microDig sensor input when using the DUMP CONFIG command with the following [BODY]:
| 00000001: | 1; configuration number |
| 00000aaa: | aaa = [0..7]; sensor input number |
The Digitizer will send out the configuration of each USB-microDig binary output as well as the sample interval value when using the DUMP CONFIG command with a special value for the 2nd data byte in the [BODY]:
| 00000001: | 1; configuration number |
| 01111111: | 127; actuator outputs flag |
