Difference between revisions of "Firmware-733 Commands"
Line 8: | Line 8: | ||
*[[Firmware-733 Command-071 |DUMP VERSION (71, 47h)]] | *[[Firmware-733 Command-071 |DUMP VERSION (71, 47h)]] | ||
− | *[[Firmware-733 Command-066 |DUMP FIRMWARE VERSION ( | + | *[[Firmware-733 Command-066 |DUMP FIRMWARE VERSION (66, 42h)]] |
*[[Firmware-73 Command-090 |SET MODE (90, 5Ah)]] | *[[Firmware-73 Command-090 |SET MODE (90, 5Ah)]] |
Revision as of 21:29, 11 January 2018
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.