Difference between revisions of "Firmware-72 Command-107"
(Created page with "==DUMP CONFIG (107, 6Bh)== The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out a CON...") |
(No difference)
|
Revision as of 05:15, 3 November 2015
DUMP CONFIG (107, 6Bh)
The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out a CONFIG message.
The USB-microDig will send out the configuration of a USB-microDig sensor input when using the DUMP CONFIG command with the following [BODY]:
| 00000001: | 1; configuration number |
| 00000aaa: | aaa = [0..7]; sensor input number |
The Digitizer will send out the configuration of each USB-microDig binary output as well as the sample interval value when using the DUMP CONFIG command with a special value for the 2nd data byte in the [BODY]:
| 00000001: | 1; configuration number |
| 01111111: | 127; actuator outputs flag |
