Firmware-72 Command-093

From I-CubeX Wiki
Revision as of 04:55, 3 November 2015 by Admin (talk | contribs) (Created page with "==MIDI OUT (93, 5Dh)== This command sets the MIDI out status of the USB-microDig. The default value is on, ie. MIDI out is enabled. The MIDI OUT command configures the USB-mi...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

MIDI OUT (93, 5Dh)

This command sets the MIDI out status of the USB-microDig. The default value is on, ie. MIDI out is enabled. The MIDI OUT command configures the USB-microDig to set the baud rate of the USB-microDig COM port to 31.25 kbps upon power-up when no USB port is connected. Instead, if a USB-microMIDICable is attached to the USB-microDig it’s MIDI messages can be received by another MIDI device. Upon completion of the command the USB-microDig sends out the same command.

The [BODY] of the MIDI OUT command is:

0xxxxxxx: xxxxxxx = 0; MIDI out off
xxxxxxx = [1..127]; MIDI out on
Retrieved from "https://infusionsystems.com/support/wiki/index.php?title=Firmware-72_Command-093&oldid=246"