Firmware-72 Command-093

MIDI OUT (93, 5Dh)

This command sets the MIDI out status of the USB-microDig. The default value is on, ie. MIDI out is enabled. The MIDI OUT command configures the USB-microDig to set the baud rate of the USB-microDig COM port to 31.25 kbps upon power-up when no USB port is connected. Instead, if a USB-microMIDICable is attached to the USB-microDig it’s MIDI messages can be received by another MIDI device. Upon completion of the command the USB-microDig sends out the same command.

The [BODY] of the MIDI OUT command is:

0xxxxxxx:	xxxxxxx = 0; MIDI out off
	xxxxxxx = [1..127]; MIDI out on