Connect-165 OSC Input

If the OSC messages match (case insensitive) the format /<digitizer_name>/<output_name> <set_value>, where digitizer_name is the name of a connected digitizer, and set_value is in {.. -128, 0 .. 127, 128 .. }, the set_value will be mapped to a SET OUTPUT message (see the firmware pages).

The following OSC messages can be sent:

set_value of OSC Message	Action
0 .. 127	enable and set pulse width modulation (if implemented) or set the I2C actuator method as per OSC message value
-128 (or less) or "off" (case insensitive)	turn output off
128 (or more) or "on" (case insensitive)	turn output on

For example, "/USB-microDig_0123/Output_01 64" will set an actuator output configured for a PWM actuator to output a pulse with a width that's half of the configured range, so in case of the default PWM configuration (ie. 1 ms range, from 1 to 2 ms) that would be 1.5 ms.

Sending the same message while the actuator output is configured for an I2C actuator will set the actuator method of the I2C actuator to 64.