Firmware-52 Command-093

MIDI THRU (93, 5Dh)

This command sets the MIDI thru status of the microDig. The default value is on, ie. MIDI thru is disabled. The MIDI THRU command configures the microDig capability to pass received MIDI messages on to its MIDI output. Upon completion of the command the USB-microDig sends out the same command.

The [BODY] of the MIDI THRU command is:

0xxxxxxx:	xxxxxxx = 0; MIDI thru off
	xxxxxxx = [1..127]; MIDI thru on