Firmware-72 Command-034
RESET (34, 22h)
The RESET command resets the USB-microDig, i.e. all internal circuitry and system variables stored in volatile memory are re-initialized. Non-volatile memory remains unchanged. The RESET command is always executed following a power-up. The RESET command does not change any stand-alone mode settings stored in non-volatile memory but reloads them in volatile memory for operational use (when in stand-alone mode).
When the USB-microDig is in host mode, the RESET command sets internal parameters stored in volatile memory to initial values as specified below.
When the USB-microDig is in stand-alone mode, the RESET command retrieves the settings as stored in non-volatile memory and sets other internal parameters as specified below.
The RESET command can also be initiated by sending a single-byte MIDI system reset (255, FFh). The single-byte MIDI system reset message can be sent anytime during any MIDI message.
Upon completion of the RESET command the RESET ACK message is sent out by the USB-microDig once (host mode) or twice (stand-alone mode) depending on the mode of operation of the USB-microDig.
There is no [BODY] associated with this command.
Example (this is the same as sending this single byte: 255 (FFh)):
- 240, 125, 0 {DEV}, 34 {RESET}, 247 (F0h, 7Dh, 00h, 22h, F7h)
Initial Values
Initial values for RESET executed with USB-microDig set to host mode:
| Mode of operation: | 0; host mode |
| MIDI out activation status: | retrieved from non-volatile memory (see MIDI OUT command) |
| System exclusive ID: | retrieved from non-volatile memory (see SET ID command) |
| Sensor input muting: | 0; off |
| Sensor activation status: | 0; off |
| Sensor sampling resolution: | 7 bit |
| Sensor sampling interval: | 10 ms (see SET INTERVAL command) |
| Actuator activation status: | retrieved from non-volatile memory (see SET OUTPUT INIT command) |
| Actuator PWM status: | retrieved from non-volatile memory (see SET OUTPUT INIT command) |
| Actuator PWM interval: | retrieved from non-volatile memory (see SET OUTPUT PULSE command) |
| Actuator PWM width: | retrieved from non-volatile memory (see SET OUTPUT PULSE command) |
Initial values for RESET executed with USB-microDig set to stand-alone mode:
| Mode of operation: | 1; stand-alone mode |
| MIDI out activation status: | retrieved from non-volatile memory (see MIDI OUT command) |
| System exclusive ID: | retrieved from non-volatile memory (see SET ID command) |
| Sensor input muting: | 0; off |
| Other sensor input settings: | retrieved from non-volatile memory (see EDIT CONFIG command) |
| Actuator activation status: | retrieved from non-volatile memory (see SET OUTPUT INIT command) |
| Actuator PWM status: | retrieved from non-volatile memory (see SET OUTPUT INIT command) |
| Actuator pulse interval: | retrieved from non-volatile memory (see SET OUTPUT PULSE command) |
| Actuator pulse width range: | retrieved from non-volatile memory (see SET OUTPUT PULSE command) |
MIDI system reset
The I-CubeX USB-microDig can also be reset using the single byte MIDI system reset command (255, FFh) in exactly the same way as when using the RESET command (34,22h). A RESET ACK (35,23h) will be sent after completion of the reset command. The MIDI system reset command can be sent anytime during any message. Any other MIDI system real-time messages that are received in the USB-microDig MIDI input are ignored.
