Firmware-72 Message-071
VERSION (71, 47h)
This message contains the USB-microDig firmware version number, hardware board version number as well as the serial number.
The [BODY] of the VERSION message is as follows:
0xxxxxxx: | xxxxxxx = [0..127]; firmware version number * 10 |
0aaaaaaa: | aaaaaaa = [0..99]; hardware board version number * 10 |
0bbbbbbb: | bbbbbbb = [0..99]; hardware board version number decimals * 1000 |
0ccccccc: | ccccccc = [0..99]; 1st serial number digits |
0ddddddd: | ddddddd = [0..99]; last serial number digits |
Example:
- 240, 125, 0 {DEV}, 71 {VERSION}, 72 {x}, 72 {a}, 0 {b}, 01 {c}, 23 {d}, 247 (F0h, 7Dh, 00h, 47h, 46h, 46h, 00h, 01h, 17h, F7h)
The firmware version for the USB-microDig is 72 / 10 = 7.2. The hardware board version number is 72 / 10 + 0 / 1000 = 7.20. The serial number is 0123. These numbers should correspond with numbers printed on the sticker at the bottom of the USB-microDig – if they don’t correspond the USB-microDig may have been upgraded to an updated firmware version after its purchase.