Firmware-733 Command-107
DUMP CONFIG (107, 6Bh)
The DUMP CONFIG command is used to obtain the current settings of the USB-microDig. Upon completion of the command the USB-microDig sends out the CONFIG message.
The USB-microDig will send out the configuration of a USB-microDig sensor input when using the DUMP CONFIG command with the following [BODY]:
00000001: | 1; configuration number |
00bbbaaa: | aaa = [0..7]; sensor input number |
bbb = [0..7]; virtual input number |
The Digitizer will send out the configuration of each USB-microDig binary output as well as the sample interval value when using the DUMP CONFIG command with a special value for the 2nd data byte in the [BODY]:
00000001: | 1; configuration number |
01111111: | 127; actuator outputs flag |