Firmware-820 Command-050
SET MUTE (50, 32h)
The SET MUTE command stops the sampling of all sensor inputs. It can be used in both modes of operation (stand-alone, host). After completion of the SET MUTE command, the WiDig does not send out any MIDI messages representing sensor values. After completion of a RESET command, a CLEAR CONFIG command or a SET MODE command the WiDig is un-muted by default. The WiDig does not send out any messages upon completion of this command.
The [BODY] of the MUTE command:
0xxxxxxx: | xxxxxxx = 0; all sensor inputs un-muted |
xxxxxxx = [1..127]; all sensor inputs muted |
Example:
- 240, 125, 0 {DEV}, 50 {SET MUTE}, 1, 247 (F0h, 7Dh, 00h, 32h, 01h, F7h)