Firmware-830 Command-090

SET MODE (90, 5Ah)

This command sets the WiDig operation mode. When switching the mode of operation, all settings stored in non-volatile memory remain unchanged but all settings stored in volatile memory, including actuator output settings, are re-initialized. When switching to stand-alone mode the initial values for stand-alone mode are used. When switching to host mode default values, including for actuator outputs, are used. See the RESET command for default values. The default value for the mode of operation, which is set after a CLEAR CONFIG command, is stand-alone mode. Upon completion of the command the WiDig sends out the MODE message.

The [BODY] of the SET MODE command is as follows:

0000000x:	x = 0; host mode
	x = 1; stand-alone mode