Firmware-52 Messages

Note that in the following listing the commands as echoed back by the microDig (to allow multiple Max/MSP objects to work with a microDig) are not included. Since many firmware 5.2 messages are the same as used in firmware 7.2, reference is made to firmware 7.2 information where applicable.

General

• RESET ACK (35, 23h)
• STATUS (37, 25h)
• VERSION (71, 47h)
• MODE (91, 5Bh)
• RUNNING STATUS (95, 60h)
• LOW POWER LEVEL (111, 6Fh)

Standalone Mode

• NAME (101, 65h)
• CONFIG (106, 6Ah)

Dual Mode

• STREAM DATA (0, 00h)
• SAMPLE DATA (4, 04h)
• I2C DATA (10, 0Bh)
• I2C PORT (125, 7Dh)
• I2C NO RESPONSE (123, 7Bh)
• I2C WRITE (126, 7Eh)
• I2C READ (127, 7Fh)