Difference between revisions of "Firmware-73 Commands"
| (2 intermediate revisions by the same user not shown) | |||
| Line 14: | Line 14: | ||
*[[Firmware-73 Command-092 |SET ID (92, 5Ch)]] | *[[Firmware-73 Command-092 |SET ID (92, 5Ch)]] | ||
| − | *[[Firmware-73 Command-032 |MUTE (32, 20h)]] | + | *[[Firmware-73 Command-032 |TOGGLE MUTE (32, 20h)]] |
*[[Firmware-73 Command-050 |SET MUTE (50, 32h)]] | *[[Firmware-73 Command-050 |SET MUTE (50, 32h)]] | ||
*[[Firmware-73 Command-051 |DUMP MUTE (51, 33h)]] | *[[Firmware-73 Command-051 |DUMP MUTE (51, 33h)]] | ||
| Line 24: | Line 24: | ||
*[[Firmware-73 Command-095 |DUMP MIDI STATUS (95, 5Fh)]] | *[[Firmware-73 Command-095 |DUMP MIDI STATUS (95, 5Fh)]] | ||
| − | *[[Firmware-73 Command-111 |DUMP COM (111, 6Fh)]] | + | *[[Firmware-73 Command-111 |DUMP COM STATUS (111, 6Fh)]] |
| Line 56: | Line 56: | ||
*[[Firmware-73 Command-020 |TABLE ENTRY (20, 14h)]] | *[[Firmware-73 Command-020 |TABLE ENTRY (20, 14h)]] | ||
| − | *[[Firmware-73 Command- | + | *[[Firmware-73 Command-030 |DUMP TABLE ENTRY (30, 1Eh)]] |
*[[Firmware-73 Command-031 |DUMP TABLE (31, 1Fh)]] | *[[Firmware-73 Command-031 |DUMP TABLE (31, 1Fh)]] | ||
Latest revision as of 04:47, 20 November 2016
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
