Firmware-733 Commands

General

This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.

• RESET (34, 22h)
• OUTPUT INIT (60, 3Ch)

• DUMP VERSION (71, 47h)
• DUMP FIRMWARE VERSION (66, 42h)

• SET MODE (90, 5Ah)
• DUMP MODE (91, 5Bh)

• SET ID (92, 5Ch)

• TOGGLE MUTE (32, 20h)
• SET MUTE (50, 32h)
• DUMP MUTE (51, 33h)

• MIDI OUT (93, 5Dh)
• DUMP MIDI OUT (96, 60h)

• MIDI STATUS (94, 5Eh)
• DUMP MIDI STATUS (95, 5Fh)

• DUMP COM STATUS (111, 6Fh)

Standalone Mode

This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.

• EDIT NAME (100, 64h)
• DUMP NAME (101, 65h)

• CLEAR CONFIG (105, 69h)
• EDIT CONFIG (106, 6Ah)
• DUMP CONFIG (107, 6Bh)

Dual Mode

This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.

• STREAM (1, 01h)
• DUMP STREAM (11, 0Bh)
• RES (2, 02h)
• DUMP RES (12, 0Ch)
• SAMPLE (4, 04h)

• INTERVAL (3, 03h)
• DUMP INTERVAL (13, 0Dh)

• FUNCTION (8, 08h)
• DUMP FUNCTION (18, 12h)

• SET OUTPUT PULSE (47, 2Fh)
• SET OUTPUT (48, 30h)
• SET OUTPUT INIT (49, 31h)
• DUMP OUTPUT PULSE (57, 39h)
• DUMP OUTPUT (58, 3Ah)
• DUMP OUTPUT INIT (59, 3Bh)

• I2C PORT (125, 7Dh)
• I2C WRITE (126, 7Eh)
• I2C WRITE SINGLE (124, 7Ch)
• I2C READ (127, 7Fh)
• I2C READ SINGLE (122, 7Ah)