Difference between revisions of "Firmware-733 Commands"
(Copied from Firmware-73 Commands, revision 1149) |
|||
| (8 intermediate revisions by the same user not shown) | |||
| Line 7: | Line 7: | ||
*[[Firmware-73 Command-060 |OUTPUT INIT (60, 3Ch)]] | *[[Firmware-73 Command-060 |OUTPUT INIT (60, 3Ch)]] | ||
| − | *[[Firmware- | + | *[[Firmware-733 Command-071 |DUMP VERSION (71, 47h)]] |
| + | *[[Firmware-733 Command-066 |DUMP FIRMWARE VERSION (66, 42h)]] | ||
*[[Firmware-73 Command-090 |SET MODE (90, 5Ah)]] | *[[Firmware-73 Command-090 |SET MODE (90, 5Ah)]] | ||
| Line 31: | Line 32: | ||
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode. | This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode. | ||
| − | *[[Firmware- | + | *[[Firmware-733 Command-100 |EDIT NAME (100, 64h)]] |
| − | *[[Firmware- | + | *[[Firmware-733 Command-101 |DUMP NAME (101, 65h)]] |
| − | *[[Firmware- | + | *[[Firmware-733 Command-105 |CLEAR CONFIG (105, 69h)]] |
| − | *[[Firmware- | + | *[[Firmware-733 Command-106 |EDIT CONFIG (106, 6Ah)]] |
| − | *[[Firmware- | + | *[[Firmware-733 Command-107 |DUMP CONFIG (107, 6Bh)]] |
Latest revision as of 20:59, 4 December 2018
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
