Difference between revisions of "Firmware-733 Commands"
| (2 intermediate revisions by the same user not shown) | |||
| Line 32: | Line 32: | ||
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode. | This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode. | ||
| − | *[[Firmware- | + | *[[Firmware-733 Command-100 |EDIT NAME (100, 64h)]] |
| − | *[[Firmware- | + | *[[Firmware-733 Command-101 |DUMP NAME (101, 65h)]] |
*[[Firmware-733 Command-105 |CLEAR CONFIG (105, 69h)]] | *[[Firmware-733 Command-105 |CLEAR CONFIG (105, 69h)]] | ||
*[[Firmware-733 Command-106 |EDIT CONFIG (106, 6Ah)]] | *[[Firmware-733 Command-106 |EDIT CONFIG (106, 6Ah)]] | ||
| − | *[[Firmware- | + | *[[Firmware-733 Command-107 |DUMP CONFIG (107, 6Bh)]] |
Latest revision as of 20:59, 4 December 2018
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
