Difference between revisions of "Firmware-733 Commands"
Line 55: | Line 55: | ||
*[[Firmware-73 Command-008 |FUNCTION (8, 08h)]] | *[[Firmware-73 Command-008 |FUNCTION (8, 08h)]] | ||
*[[Firmware-73 Command-018 |DUMP FUNCTION (18, 12h)]] | *[[Firmware-73 Command-018 |DUMP FUNCTION (18, 12h)]] | ||
+ | |||
+ | *[[Firmware-73 Command-020 |TABLE ENTRY (20, 14h)]] | ||
+ | *[[Firmware-73 Command-030 |DUMP TABLE ENTRY (30, 1Eh)]] | ||
+ | *[[Firmware-73 Command-031 |DUMP TABLE (31, 1Fh)]] | ||
*[[Firmware-73 Command-047 |SET OUTPUT PULSE (47, 2Fh)]] | *[[Firmware-73 Command-047 |SET OUTPUT PULSE (47, 2Fh)]] |
Latest revision as of 20:59, 4 December 2018
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.