Difference between revisions of "Firmware-812 Commands"
(Created page with "Since many firmware 8.12 commands are the same as used in firmware 8.11, reference is made to firmware 8.11 information where applicable. ==General== This section describes...") |
|||
| Line 3: | Line 3: | ||
==General== | ==General== | ||
| − | This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation | + | This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode. |
*[[Firmware-811 Command-034 |RESET (34, 22h)]] | *[[Firmware-811 Command-034 |RESET (34, 22h)]] | ||
Revision as of 02:54, 27 July 2020
Since many firmware 8.12 commands are the same as used in firmware 8.11, reference is made to firmware 8.11 information where applicable.
General
This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
