Difference between revisions of "Firmware-820 Commands"
(→Standalone Mode) |
|||
| Line 38: | Line 38: | ||
*[[Firmware-811 Command-105 |CLEAR CONFIG (105, 69h)]] | *[[Firmware-811 Command-105 |CLEAR CONFIG (105, 69h)]] | ||
| − | *[[Firmware- | + | *[[Firmware-820 Command-106 |EDIT CONFIG (106, 6Ah)]] |
*[[Firmware-811 Command-107 |DUMP CONFIG (107, 6Bh)]] | *[[Firmware-811 Command-107 |DUMP CONFIG (107, 6Bh)]] | ||
*[[Firmware-811 Command-108 |DUMP ALL CONFIG (108, 6Ch)]] | *[[Firmware-811 Command-108 |DUMP ALL CONFIG (108, 6Ch)]] | ||
*[[Firmware-811 Command-109 |DUMP CONFIG RANGE (109, 6Dh)]] | *[[Firmware-811 Command-109 |DUMP CONFIG RANGE (109, 6Dh)]] | ||
| − | |||
==Dual Mode== | ==Dual Mode== | ||
Revision as of 21:18, 15 February 2022
Since many firmware 8.20 commands are the same as used in firmware 8.11 and 8.12, reference is made to firmware 8.11 or 8.12 information where applicable.
General
This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
