Difference between revisions of "Firmware-820 Commands"
(→General) |
(→Standalone Mode) |
||
| Line 33: | Line 33: | ||
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode. | This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode. | ||
| − | *[[Firmware- | + | *[[Firmware-820 Command-100 |EDIT NAME (100, 64h)]] |
| − | *[[Firmware- | + | *[[Firmware-820 Command-101 |DUMP NAME (101, 65h)]] |
| − | *[[Firmware- | + | *[[Firmware-820 Command-105 |CLEAR CONFIG (105, 69h)]] |
*[[Firmware-820 Command-106 |EDIT CONFIG (106, 6Ah)]] | *[[Firmware-820 Command-106 |EDIT CONFIG (106, 6Ah)]] | ||
| − | *[[Firmware- | + | *[[Firmware-820 Command-107 |DUMP CONFIG (107, 6Bh)]] |
| − | *[[Firmware- | + | *[[Firmware-820 Command-108 |DUMP ALL CONFIG (108, 6Ch)]] |
| − | *[[Firmware- | + | *[[Firmware-820 Command-109 |DUMP CONFIG RANGE (109, 6Dh)]] |
==Dual Mode== | ==Dual Mode== | ||
Revision as of 00:02, 7 March 2022
Since many firmware 8.20 commands are the same as used in firmware 8.11 and 8.12, reference is made to firmware 8.11 or 8.12 information where applicable.
General
This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
