Difference between revisions of "Firmware-73 Commands"
| Line 14: | Line 14: | ||
*[[Firmware-73 Command-092 |SET ID (92, 5Ch)]] | *[[Firmware-73 Command-092 |SET ID (92, 5Ch)]] | ||
| − | *[[Firmware-73 Command-032 |MUTE (32, 20h)]] | + | *[[Firmware-73 Command-032 |TOGGLE MUTE (32, 20h)]] |
*[[Firmware-73 Command-050 |SET MUTE (50, 32h)]] | *[[Firmware-73 Command-050 |SET MUTE (50, 32h)]] | ||
*[[Firmware-73 Command-051 |DUMP MUTE (51, 33h)]] | *[[Firmware-73 Command-051 |DUMP MUTE (51, 33h)]] | ||
Revision as of 03:48, 20 November 2016
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
