Difference between revisions of "Firmware-770 Commands"
| Line 24: | Line 24: | ||
*[[Firmware-770 Command-096 |DUMP MIDI OUT (96, 60h)]] | *[[Firmware-770 Command-096 |DUMP MIDI OUT (96, 60h)]] | ||
| − | *[[Firmware-770 Command-094 |MIDI | + | *[[Firmware-770 Command-094 |MIDI CONFIG (94, 5Eh)]] |
| − | *[[Firmware-770 Command-095 |DUMP MIDI | + | *[[Firmware-770 Command-095 |DUMP MIDI CONFIG (95, 5Fh)]] |
*[[Firmware-770 Command-111 |LOW POWER AND COM (111, 6Fh)]] | *[[Firmware-770 Command-111 |LOW POWER AND COM (111, 6Fh)]] | ||
Latest revision as of 00:38, 7 March 2022
Since most firmware 7.70 commands are the same as used in firmware 8.20, reference is made to firmware 8.20 information where applicable.
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
