Firmware-812 Commands

Since many firmware 8.12 commands are the same as used in firmware 8.11, reference is made to firmware 8.11 information where applicable.

General

This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode.

• RESET (34, 22h)
• OUTPUT INIT (60, 3Ch)

• DUMP FIRMWARE VERSION (66, 42h)
• DUMP VERSION (71, 47h)

• SET MODE (90, 5Ah)
• DUMP MODE (91, 5Bh)

• SET ID (92, 5Ch)

• SET SOLO (32, 20h)
• DUMP SOLO (33, 21h)
• SET MUTE (50, 32h)
• DUMP MUTE (51, 33h)

• BLE-MIDI (93, 5Dh)
• DUMP BLE-MIDI (96, 60h)

• MIDI STATUS (94, 5Eh)
• DUMP MIDI STATUS (95, 5Fh)

• LOW POWER (111, 6Fh)

Standalone Mode

This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.

• EDIT NAME (100, 64h)
• DUMP NAME (101, 65h)

• CLEAR CONFIG (105, 69h)
• EDIT CONFIG (106, 6Ah)
• DUMP CONFIG (107, 6Bh)
• DUMP ALL CONFIG (108, 6Ch)
• DUMP CONFIG RANGE (109, 6Dh)

Dual Mode

This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.

• STREAM (1, 01h)
• DUMP STREAM (11, 0Bh)
• RES (2, 02h)
• DUMP RES (12, 0Ch)
• SAMPLE (4, 04h)

• INTERVAL (3, 03h)
• DUMP INTERVAL (13, 0Dh)

• FUNCTION (8, 08h)
• DUMP FUNCTION (18, 12h)

• TABLE ENTRY (20, 14h)
• DUMP TABLE ENTRY (30, 1Eh)
• DUMP TABLE (31, 1Fh)

• SET OUTPUT PULSE (47, 2Fh)
• SET OUTPUT (48, 30h)
• SET OUTPUT INIT (49, 31h)
• DUMP OUTPUT PULSE (57, 39h)
• DUMP OUTPUT (58, 3Ah)
• DUMP OUTPUT INIT (59, 3Bh)

• I2C PORT (125, 7Dh)
• I2C WRITE (126, 7Eh)
• I2C WRITE SINGLE (124, 7Ch)
• I2C READ (127, 7Fh)
• I2C READ SINGLE (122, 7Ah)