Difference between revisions of "Firmware-812 Commands"
(→Dual Mode) |
|||
| Line 24: | Line 24: | ||
*[[Firmware-811 Command-096 |DUMP BLE-MIDI (96, 60h)]] | *[[Firmware-811 Command-096 |DUMP BLE-MIDI (96, 60h)]] | ||
| − | *[[Firmware-811 Command-094 |MIDI | + | *[[Firmware-811 Command-094 |MIDI CONFIG (94, 5Eh)]] |
| − | *[[Firmware-811 Command-095 |DUMP MIDI | + | *[[Firmware-811 Command-095 |DUMP MIDI CONFIG (95, 5Fh)]] |
*[[Firmware-812 Command-111 |LOW POWER (111, 6Fh)]] | *[[Firmware-812 Command-111 |LOW POWER (111, 6Fh)]] | ||
Latest revision as of 16:06, 5 March 2022
Since many firmware 8.12 commands are the same as used in firmware 8.11, reference is made to firmware 8.11 information where applicable.
General
This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
