Difference between revisions of "Firmware-830 Commands"
(→General) |
|||
| Line 20: | Line 20: | ||
*[[Firmware-830 Command-051 |DUMP MUTE (51, 33h)]] | *[[Firmware-830 Command-051 |DUMP MUTE (51, 33h)]] | ||
| − | *[[Firmware-830 Command-093 | | + | *[[Firmware-830 Command-093 |WIRELESS (93, 5Dh)]] |
| − | *[[Firmware-830 Command-096 |DUMP | + | *[[Firmware-830 Command-096 |DUMP WIRELESS (96, 60h)]] |
*[[Firmware-830 Command-094 |MIDI CONFIG (94, 5Eh)]] | *[[Firmware-830 Command-094 |MIDI CONFIG (94, 5Eh)]] | ||
| Line 27: | Line 27: | ||
*[[Firmware-830 Command-111 |LOW POWER (111, 6Fh)]] | *[[Firmware-830 Command-111 |LOW POWER (111, 6Fh)]] | ||
| − | |||
==Standalone Mode== | ==Standalone Mode== | ||
Latest revision as of 15:45, 7 June 2023
General
This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting BLE-MIDI out operation and setting running status and obtaining MIDI status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.
- CLEAR CONFIG (105, 69h)
- EDIT CONFIG (106, 6Ah)
- DUMP CONFIG (107, 6Bh)
- DUMP ALL CONFIG (108, 6Ch)
- DUMP CONFIG RANGE (109, 6Dh)
Dual Mode
This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
