Difference between revisions of "Firmware-52 Messages"
(Created page with "Note that in the following listing the commands as echoed back by the microDig (to allow multiple Max/MSP objects to work with a microDig) are not included. Since many firmwar...") |
|||
| Line 11: | Line 11: | ||
*[[Firmware-72_Message-095 |RUNNING STATUS (95, 60h)]] | *[[Firmware-72_Message-095 |RUNNING STATUS (95, 60h)]] | ||
*[[Firmware-62_Message-111 |LOW POWER LEVEL (111, 6Fh)]] | *[[Firmware-62_Message-111 |LOW POWER LEVEL (111, 6Fh)]] | ||
| − | |||
Latest revision as of 18:43, 20 January 2016
Note that in the following listing the commands as echoed back by the microDig (to allow multiple Max/MSP objects to work with a microDig) are not included. Since many firmware 5.2 messages are the same as used in firmware 7.2, reference is made to firmware 7.2 information where applicable.
General
- RESET ACK (35, 23h)
- STATUS (37, 25h)
- VERSION (71, 47h)
- MODE (91, 5Bh)
- RUNNING STATUS (95, 60h)
- LOW POWER LEVEL (111, 6Fh)
Standalone Mode
