Laser Strings

What you need

For this walkthrough, you will need:

• A WiDig with power supply (USB cable or USB battery pack)
• A Flash sensor
• A ReachCloseD
• A SeeLaser-GreenWide or any laser of your choice
• An iPad (or other iOS device) running GarageBand

Hardware Setup

First, plug in the ReachCloseD into input 1, The Flash into input 2, and the laser into any other slot:

Next, connect the WiDig via a micro-USB cable to a charged USB battery pack, or a USB power supply.

Pairing for Configuration

Follow either the WiDig QuickStart pages for BLE pairing instructions

EditorX Configuration

Now it's time to set up the sensor to MIDI message mappings in EditorX!

First, select the BLE port

EditorX Configuration

Now its time to set up the sensors to map to MIDI messages. In the example, we emit two parameters:

1.) The ReachCloseD's distance value is mapped to pitch bend

2.) The Flash sensor emits a note on/off pair when the laser light is interrupted