Difference between revisions of "Firmware-72 Commands"
(→Dual mode) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
==General== | ==General== | ||
| + | |||
| + | This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode. | ||
*[[Firmware-72 Command-034 |RESET (34, 22h)]] | *[[Firmware-72 Command-034 |RESET (34, 22h)]] | ||
| Line 19: | Line 21: | ||
*[[Firmware-72 Command-094 |MIDI RUNNING STATUS (94, 5Eh)]] | *[[Firmware-72 Command-094 |MIDI RUNNING STATUS (94, 5Eh)]] | ||
| − | *[[Firmware-72 Command-095 |DUMP RUNNING (95, 5Fh)]] | + | *[[Firmware-72 Command-095 |DUMP RUNNING STATUS (95, 5Fh)]] |
*[[Firmware-72 Command-111 |DUMP COM (111, 6Fh)]] | *[[Firmware-72 Command-111 |DUMP COM (111, 6Fh)]] | ||
| Line 25: | Line 27: | ||
==Standalone Mode== | ==Standalone Mode== | ||
| + | |||
| + | This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode. | ||
*[[Firmware-72 Command-100 |EDIT NAME (100, 64h)]] | *[[Firmware-72 Command-100 |EDIT NAME (100, 64h)]] | ||
| Line 35: | Line 39: | ||
==Dual Mode== | ==Dual Mode== | ||
| + | |||
| + | This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode. | ||
*[[Firmware-72 Command-001 |STREAM (1, 01h)]] | *[[Firmware-72 Command-001 |STREAM (1, 01h)]] | ||
Latest revision as of 16:50, 3 November 2015
General
This section describes the messages and commands for resetting the USB-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
