Difference between revisions of "Firmware-52 Commands"
(Created page with "Since many firmware 5.2 commands are the same as used in firmware 7.2, reference is made to firmware 7.2 information where applicable. ==General== This section describes the...") |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Since many firmware 5.2 commands are the same as used in firmware 7.2, reference is made to firmware 7.2 information where applicable. | + | Since many firmware 5.2 commands are the same as used in firmware 7.2 or 6.2, reference is made to firmware 7.2 or 6.2 information where applicable. |
==General== | ==General== | ||
| Line 16: | Line 16: | ||
*[[Firmware-72 Command-032 |MUTE (32, 20h)]] | *[[Firmware-72 Command-032 |MUTE (32, 20h)]] | ||
*[[Firmware-72 Command-050 |SET MUTE (50, 32h)]] | *[[Firmware-72 Command-050 |SET MUTE (50, 32h)]] | ||
| + | |||
| + | *[[Firmware-52 Command-093 |MIDI THRU (93, 5Dh)]] | ||
*[[Firmware-72 Command-094 |MIDI RUNNING STATUS (94, 5Eh)]] | *[[Firmware-72 Command-094 |MIDI RUNNING STATUS (94, 5Eh)]] | ||
| Line 21: | Line 23: | ||
*[[Firmware-62 Command-111 |LOW POWER LEVEL (111, 6Fh)]] | *[[Firmware-62 Command-111 |LOW POWER LEVEL (111, 6Fh)]] | ||
| − | |||
Latest revision as of 18:49, 20 January 2016
Since many firmware 5.2 commands are the same as used in firmware 7.2 or 6.2, reference is made to firmware 7.2 or 6.2 information where applicable.
General
This section describes the messages and commands for resetting the Wi-microDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining the Bluetooth port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the USB-microDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the USB-microDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
